Hi there,
Does anyone know how to erase the fault codes on 1991 mi16 1.9. I have got fault code 44 (knock sensor) coming up. Have serviced the car, fixed a vacum leak, dissy cap, set the air/fuel ratio correctly and also chaged knock sensor but need to erase the code to see if it has fixed the problem.
Anyone got any ideas
Cheers
Full Version: Erasing Fault Codes On Mi16
Disconnecting battery is one way. The proper way I can't remember.
Welcome to the forum
Could you fill in your location on your profile please.
Welcome to the forum
Could you fill in your location on your profile please.
well you could say that it is the correct way.
it's not like the codes won't come back if errors are still present
.
it's not like the codes won't come back if errors are still present
.
Ah cheers.... Yeah i have tried that one and the light still comes back.
Has anyone come across this problem before?? If so anything else i could check before i start attacking the wiring
Has anyone come across this problem before?? If so anything else i could check before i start attacking the wiring
Set "Ground" for the pin2 of diagnostic connector for 15 seconds
that erases error. but they will come back if its permanent error which occurs again
you can check it and see what error it gives. its easy.
that erases error. but they will come back if its permanent error which occurs again
you can check it and see what error it gives. its easy.
QUOTE (lee-bg @ Nov 23 2007, 09:31 PM)
Set "Ground" for the pin2 of diagnostic connector for 15 seconds
that erases error. but they will come back if its permanent error which occurs again
you can check it and see what error it gives. its easy.
that erases error. but they will come back if its permanent error which occurs again
you can check it and see what error it gives. its easy.
Hehe I'm following you around the net! JUst read this on the BX forum too.
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.